You are here

Amtrak to expand speed control at deadly US train crash site

By AP - May 17,2015 - Last updated at May 17,2015

PHILADELPHIA — US passenger train operator Amtrak will expand its use of a speed restriction system on Philadelphia's northbound rails and abide by other federal directives issued after one of its trains crashed in the city last week, killing eight people.

The automatic train control system already is being used for southbound trains approaching the curve where Tuesday's derailment occurred. The system notifies an engineer when a train is above the speed limit and automatically applies the brakes if the engineer doesn't slow down the train.

The US Federal Railroad Administration on Saturday ordered Amtrak to expand use of the system.

Amtrak said Saturday it would comply, adding that its "overarching goal is to provide safe and secure rail passenger travel."

The company hopes to resume limited service between Philadelphia and New York on Monday and full service on Tuesday.

The train was traveling from Washington, DC, to New York when it flew off the tracks in Philadelphia. About 200 people were injured, and at least eight people remained in critical condition in Philadelphia hospitals Saturday. All were expected to survive.

Investigators have been looking into why the train hit the speed of about 171kph in a 80kph zone. The FBI also is looking into the possibility that the windshield of the train was hit by an object shortly before the train derailed. The engineer, who was injured in the crash, told authorities he did not recall anything in the few minutes before it happened.

The Federal Railroad Administration also ordered Amtrak to analyse curves to assess risks on the Northeast Corridor, the busy stretch of tracks between Washington and Boston, and determine if more can be done to improve safety.

"In areas where approach speed is significantly higher than curve speed, the appropriate technology intended to prevent over-speed derailments must be implemented immediately," the agency said.

Amtrak also will have to increase the amount and frequency of signage alerting engineers and conductors of the maximum authorised speed.

Amtrak posted a message on its website Saturday touting a "very strong" safety record, including a claim that yearly derailments fell from 80 to 28 between 2000 and 2014.

After the crash, Amtrak President Joseph Boardman vowed to have the next-generation positive train control system in operation along the railroad by the end of the year, as Congress mandated in 2008. The system uses transponders, wireless radio and computers to prevent trains from going over the speed limit.

Company spokesman Craig Schulz said Saturday that Amtrak also plans to look into whether it can partially activate some of the capabilities already installed along the Northeast Corridor without delaying the complete activation of the next-generation system later this year. The system — which can be programmed with specific speed limits based on work schedules, track curvature and other conditions — is in service on only 80.4 km of the 363.7 km between Washington and New York.

Officials say the railroad has been repairing the tracks, signals and overhead power lines since the crash.

up
42 users have voted.

Newsletter

Get top stories and blog posts emailed to you each day.